We will configure ipv6 static and ipv6 default routing on cisco routers. In this lab, you will configure hosts and device interfaces with ipv6 addresses. Similarly, repeat this procedure with pc1 and pc2
Why The Smashing Pumpkins’ bassist disappeared without a trace
R1’s g0/0 and g0/1 both have link local addresses on them, but those routes don’t appear in the routing table. Here, we will learn ipv6 static route and ipv6 default route. In part 4, you will configure static and default routing on r1 and r2 to enable full connectivity between the routers using ipv6.
R1 and r2 are connected with a serial link.
To demonstrate this topology, i will use the following topology: Change the settings from static to automatic and then after a few seconds, the ipv6 address and default gateway are displayed. In this packet tracer summary activity, you will configure static, default, and floating static routes for both the ipv4 and ipv6 protocols. Now let’s look at how to configure ipv6 static routes on our.
Configure ipv4 static and floating. In this lab, you will configure the entire network to communicate using only ipv6 addressing, including configuring the routers and pcs. Once again, the static routing being used here is not meant to. You will issue show commands to view ipv6 unicast addresses.
